Issue
- The hob cannot be activated or is not operating
- The hob does not work
- The hob display is blank, the appliance appears "dead"
Applies to
- electric (ceramic) hob
- induction hob
Resolution
If the hob does not work/does not display any symbols right after being connected, this indicates possible incorrect installation.
Check if the hob is correctly connected to the power supply, according to the installation instructions. Contact the installer.
All electrical connections should be made by a qualified electrician.
If the hob stopped working after some time after installation, please check the causes below to rectify the problem:
1. Make sure that no more than 10 seconds passed since you activated the hob.
Turn on the appliance again and select heat setting.
Automatic Switch Off - The function deactivates the hob automatically if you do not set the heat setting after you activate the hob.
2. Make sure that several symbols were not touched at the same time.
Touch only one sensor field.
3. Clean the control panel of water and fat stains.
4. Deactivate the Child Safety Lock ("L" or padlock symbol is displayed when the lock is active).
Refer to the full description in the user manual, as the procedure depends on the model of the appliance. Download the user manual.
5. Deactivate the STOP+GO function.
Refer to the full description in the user manual, as the procedure depends on the model of the appliance.
6. Deactivate the Demo Mode.
7. Contact an Authorized Service Centre.
If the above advice does not resolve the problem, we recommend requesting a visit by a service engineer.
